When i crawled under the truck, the bendix was still stuck in the flexplate teeth. But on my 2011 silverado ltz, sometimes when i go to start it, it like starts but it sounds like the starter is grinding.

diseal trucks Dieseltrucks Diesel trucks, Chevy diesel

2003 chevrolet silverado 2500 hd.

Chevy silverado starter grinding. I would also buy the proper starter bolts for these starters. If this noise continues without the starter being replaced, it can cause damage to the engine's feel, which is a rather expensive repair to have completed. I would get a pack of shims out of the help section and install one of the thinner ones and keep going up until the noise goes away.

Set your multimeter to be on the ohms scale. They are available from dealers and auto supplies. The truck making the noise is a 1996 chevy, 2500, 4x4, 6.5 turbo diesel.

Almost turning over but not quite, but then started normally (with the the he grinding sound). My chevy silverado grinds on start up very bad, on quiet mornings you can hear it a block away when i start it to leave for work. Interior lights dim when starting the car

Removed the starter and had it tested at a local autozone store two different times. Im looking at a 2007 3500 duramax to buy within the next few days or so, so im hoping that this isnt a repair that might cost alot. Thereof, how do you test a starter relay?

Discussion starter · #1 · mar 21, 2016. I replaced the engine temperature guage sensor with a duralast one and also replaced the thermostat with a duralast one. It looks like the alignment of the starter was off.

Place one probe on the lead on the ignition circuit terminal and the other on the ground lead. You can tell a lot about what’s going on with a vehicle by carefully listening for changes. The chevy's have tendency to cause this as exhaust is near starter and a heat shield.

I have a 6.0 gmc sierra 2500 hd that in the past few days has developed a problem with the starter. Grinding everyonce in awhile when starting. If the grinding symptom is ignored, it may also result in.

Found a used starter off a wrecked lbz with under 50,000 on it. Chevy starter fitment is not a one size fits all situation. It always starts up, but its almost like the starter is not.

When i bought the truck, the starter made a horrible grinding/whining noise and the truck wouldn't start. So i have a 1991 chevy silverado 5.7 liter v8 2500 with 175,000 miles on the odometer. If you need a 168 tooth starter, get one for a 1995 chevy pickup with a v8 engine.

Replaced the starter(ac delco) and flexplate(ac delco). The starter motor on your chevrolet engine is designed to spin when you turn on the key, which spins the flywheel and starts up the engine. Noises coming from the starter and the vehicle itself not starting are the most common symptoms of a bad starter in your silverado.

Chevy truck forum | silverado sierra gmc truck forums. The relationship between the flywheel and the starter gear can be a bit finicky, and if there isn't enough clearance between the two gears, you can get grinding sounds, and have problems starting. However, grinding may also happen inside the starter motor.

So i had the starter replaced. In either case, it's something that can't be fixed on the car. If you need a 153 tooth starter, get one for a 1995 z28 camaro with an lt1 engine.

The 2003 chevy silverado starter solenoid is underneath the engine on the front passenger’s side. Solonoid (on side of starter) could be going out (intermitent starting) and can usually be replaced without replacing starter. Both have been replaced at the same time one year ago.

If the starter is crashing into the flywheel and then turning the motor over it will give you a grinding noise. I have a question about my 97 tahoe 4x4. Took starter back to gm and they gave me my $ back you can try the delco, mabey you can get a good one.

I have a 92 chevy 1500 stepside i tried 3 starters still getting same issue when you go to start it don’t makes like a clank noise like it wants to but don’t like on the 3 or 4 th turn then it will start not sure if i’m getting right starter for that vech some one said there’s a small open end and large open end on starters can’t find help fig witch one goes on my veh I just did the starter & i hoping that would be it. When the starter drive gear is worn out or not engaging properly, they will often produce a grinding noise that is similar to the one that is heard if you start your engine and then accidentally hit the starter again.

Otherwise it runs normally and. It was good for a few days but again its making the grinding noise. Silverado 2500 hd / 2003 / grinding everyonce in.

After getting everything put back together, grinded on the first start. I recently picked up a 1989 chevy r3500 with a big block 454 in it. First time it failed the drive extension test.

The starter was making grinding noise when i tried to start the truck. Im thinking the flexplate needs to be replaced but the starter keeps falling down a little an when i push it back into place it starts. When i start the truck, it sounds like a grinding noise coming from under vehicle.

Your ears are the best diagnostic tool that you have. A neighbor heard it and said he thought it was the starter and fly wheel grinding together because of wear, after a few weeks it finally went completely out and once again i was advised while broke down on the road that it was believed to be this problem, after.