Mercruiser Starter Solenoid Bolt

Mercruiser, marine power & omc late models. This starter replaces the following part numbers:

Mercury / Mariner / Yamaha 30 / 40 Hp Starter / 12V CCW

Replace this starter with # 10090lh.

Mercruiser starter solenoid bolt. 5.0 & 5.7l (1998 & up ) with a 14 flywheel. Same as 10033, but this starter is c.c.w. After 3 days of use, the short bolt had sheared off.

Broken starter bolt in mercruiser 3.0l alpha one engine block remove the rest of the starter and the thread of the bolt that broke will normally rotate undone with very little effort.if not a small hole about 4 to 5 mm or 1/8 to 1/4 and bang a torx bit into the hole and rotate undone. Mercruiser model number reference guides. Satisfaction rating 5 out of 5 ( 11 ratings ) $289.95.

Find starter motors & remote mount slave solenoids for your mercruiser stern drive using the application chart from the mercury quicksilver catalog. I first tried a drill, no luck being the boly is hardened steel. I tightened up the bolts, reset the timing and it ran great.

Verifying your oem part number off of your old starter is the best way to confirm fitment. Delco permanent magnet gear reduction 2 bolt starter Mercruiser starters, solenoids, find direct replacement starters, alternators, solenoids and other mercruiser boat parts javascript is disabled on your browser.

This product will be cross shipped from one of our secondary warehouses. No way to get at the bolt to drill without removing the engine. 4.5” starter, mod 1 style fits 460.

Rotation replace with new api gear reduction starter # 10080nd st 80lh factory reman 12v c.c.w. Direction of rotation is determined as to viewing the starter from the drive end. Please note the additional handling time.

Please fully review the specifications for this starter to ensure fitment. Common solenoid/starter problem solution ignition system. Post a buying request and when it’s approved, suppliers on our site can quote.

Danw , i had the same problem, recently bought a 95 bayliner capri, mercruiser 3.o l. With staggered (offset) bolt patterns can be replaced with this starter. I discovered that the starter bolts were half way tightened after hearing a loud metal on metal noise when i went to start it for the first time.

Replace with new api gear reduction starter # 10079ndlh st 80 factory reman 12v fits chris craft & harman marine. Buying request hub makes it simple, with just a few steps: The previous owner says he replaced the starter recently.

Replace this starter with # 10094. I was told the boat needs the timing reset. If you need parts not listed in the application guide, please see:

US14.20 Starter Solenoid Relay Set 12V Black for Jeep